Skip to content

Back to Videos

How to Flush a Water Heater, Step by Step

Flushing your water heater once a year removes sediment, cuts noise and extends its life. This clear walkthrough shows the full job in under ten minutes.

By Marcus Reed

Clean, bright bathroom with hot water on tap

Sediment is the number one reason tank water heaters fail early. In this video from This Old House, a master plumber shows how to drain and flush a tank safely, a job most homeowners can do once a year with a garden hose and a bucket.

Before you start

  • Turn off the power (electric) or set the gas valve to pilot.
  • Close the cold water supply valve at the top of the tank.
  • Let the water cool for a few hours, as it can scald.
  • Have a garden hose long enough to reach a floor drain or the yard.

The steps in the video

  1. Connect the hose to the drain valve at the base of the tank.
  2. Open a hot tap upstairs so air can enter and the tank drains freely.
  3. Open the drain valve and let the tank empty.
  4. Briefly open the cold supply to stir up and rinse out remaining sediment.
  5. Close the drain valve, refill the tank and restore power or gas.

"If the drain valve is plastic and stiff, do not force it. That is the moment to call us." Marcus Reed, Northside Plumbing & Heating

Our notes for Chicago homes

Our water is moderately hard, so tanks here collect sediment faster than average. We recommend a flush every 12 months, and every 6 months if you hear rumbling. If your heater is over ten years old, has never been flushed, or shows rust at the base, ask a licensed plumber to do it: an old valve can fail once opened.

Need help? Book a service through our profile page.

Comments

No comments yet.